Feature:
1. [Small Error] The incubator controller temperature sensor and humidity sensor measure temperature and humidity with a small error, long use time. Fahrenheit and Celsius as one, two modes freely switchable.
2. [Easy To Operate] Thermostat is connected to the corresponding terminal to start the pair function. Digital tube display, simple operation of the panel function, sturdy and practical, stable performance and long service life.
3. [Setting Free] Adjustments have been made to the temp, humidity, egg turning and ventilation to match the settings required for incubation. Normally, no settings are needed, just connect to the power supply and use.
4. [Factory Settings] Incubator controller for temperature 38 degrees C, humidity 60percent RH; egg turning cycle 90 minutes, egg turning time 180 seconds; ventilation 120 minutes, ventilation 30 seconds, automatic egg turning.
5. [Maintenance] Temp and humidity sensor is made of precise, micro molecular material, do not come into direct contact with water; the surface should be cleaned of dust regularly, otherwise the accuracy of the measurement will be affected.
Specification:
Item Type: Incubator Controller
Material: Plastic
Size: Approx. 9.7 x 9 x 5.4cm / 3.8 x 3.5 x 2.1in
Use: Electronic digital display thermostat for poultry, reptile and aquaculture hatching
Number of Control Output Channels: 5 Channels (Temperature Control, Egg Turning, Over Temperature, Humidity Control, Alarm)
Ambient Temperature: -10-60 degrees C, 14-105 degrees F
Temperature Range: 0-99 celsius , 0-110 Fahrenheit
Humidity Range: 0-99percent RH
Relative Humidity: <85percent RH
Humidity Accuracy: +/-3percent RH
Temperature Accuracy: +/-0.1 celsius , +0.1 Fahrenheit
Operating Voltage: AC220V/110V
Number of Egg Turning: Up to 999 Times Recorded
Egg Turning Cycle: 0-999 Minutes Adjustable (Factory Setting Is 120 Minutes)
Egg Turning Time: 0-999 Seconds Adjustable (Factory Setting Is 180 Seconds)
Ventilation Cycle: 0-999 Minutes Adjustable (Factory Setting Is 120 Minutes)
Ventilation Time: 0-999 Seconds Adjustable (Factory Setting Is 30 Seconds).
Package List:
1 x Incubator Controller1 x Temperature Sensor1 x Humidity Sensor1 x Manual1 x Screwdriver2 x Fixed Frame2 x Terminal Accessories
Note:
1. If you need to change the temperature and humidity parameters, please refer to the manual, do not set other parameters to avoid operating errors, affecting your use and bringing you unnecessary losses.2. Manual measurement, please allow some errors.
