Regulator Temperature Control Switch Sensor Thermostat NTC Temperature Controller W1209

Label:Yes Static current: ≤ 35MA, attract current ≤ 65MA Measurement input: NTC (10K 0.5%) Waterproof Sensor High temperature protection 0-110 ResolutionWhen temperature is 0.1 the resolution is -9.9~99.9, other temperature segment is 1 Output power: 10A relay Size: 48 * 40*16mm(1.89 * 1.57*0.63in) Output voltage: for DC 12V Refresh rate: 0.5S Control accuracy: 0.1 Temperature control mode: ON / OFF Supply voltage: for DC 12V Environmental requirements: -10 ~ 60 Humidity 20% -85% Package:1PCS Temperature Controller Hysteresis accuracy: 0.1 Temperature range :-50-110 Instructions:

1. Please pay attention for your first use. You need wait 6s after your setting data, the module will save the date you have set after 6s. 2. Short press button SET: If you start the time setting mode , Nixie tube will blink. You could adjust the time T1 and T2 by button+ and button-. Please wait 5s after your setting date, the module will save the date you have set after 5s 3. Long press button SET: if you start the parameter setting mode. There are two group parameter for your choice : P0 and P1. You could switch P0 or P1 by short press SET. Under the parameter P0 and P1,you could set the timing mode by the button+ and button-.

P0--0: timing mode is 0--999 seconds P0--1: timing mode is 0--999 minutes P0--2: timing when the pattern is 0--999 P1--0: T1 time delay relay (T1 timer) P1--1: T1 delay time relay releases (T1 timer) P1--2: time delay relay after T1 (T1 timer), then the delay time T2 successor electrical release (T2 timing) ends. P1--3: T1 delay time relay releases (T1 timer), then the delay time T2 successor Electric energized (T2 timing) ends. P1--4: time delay relay after T1 (T1 timer), then the delay time T2 successor electrical release (T2 timer), repeat the cycle. P1--5: T1 delay time relay releases (T1 timer), then the delay time T2 successor Electric energized (T2 timer), repeat the cycle.