The merchant warrants that their products comply with all applicable laws, and are offered only if they comply with Joom’s policies and EU Product Safety and Compliance laws.
Product Name：LED Integrated Led Taillight
Material：ABS
Placement On Vehicle：Motorcycle Rear Fender
Function:Running Light/Brake Light/Turn Signal
Light Color：Red
Fitment：Fit For Harley Fat Bob FXFB/FXFBS US Model 2018-2021
Package Included: A Set of LED Integrated Led Taillight
Installation：
1. Remove Seat From The Bike.
2. Remove The Black Plastic Reflector From The Inside Of The
Rear Fender. It Is Attached To The Fender With Double Sided
Tape.
3. Clean The Underside Folded Fender Lip To Remove All Road
Grime And Dirt.
4. Test Fit The New Integrated Led Taillight To Underside Folded
Lip Of The Fender. Make Sure It Is Centered, Then Mark The
Position With A Grease Pencil For A Guide. Note: The Integrated Led Taillight Mounts On The Folded Lip Of The Fender
Not Behind It.
5. Remove The Red Backing Tape On The Back Of The Taillight.Press The Integrated Led Taillight Into Place Using Your Marks From Step 4 As A Guide.
6. Route The Wiring Harnesses From The Integrated Led Taillight On The Inside Of The Fender To Under The Seat.
7. Use The Tie Wrap Holders And Tie Wraps, Secure The Wiring Harnesses To The Underside Of The Rear Fender To Prevent Them From Coming In Contact With The Rear Tire.Clean The Tie Wrap Holder Mounting Locations Of All Road
Grime And Dirt And Prep The Area With The Alcohol Wipe.
8. Locate The Rear Left And Right Turn Signal Connecters Under The Seat. The Grey Connectors Are The Left Side. The Black Connectors Are The Right Side.
9. Disconnect The Left Side (Grey) Rear Lighting Connectors And Connect The Integrated Led Taillight Harness With The Internal Purple Wire (Left Side) Inline To Both Left Side
(Grey) Connecters.
10. Disconnect The Right Side (Black) Rear Lighting Connectors And Connect The Integrated Led Taillight Harness With The Internal Brown Wire (Right Side) Inline With Both Right Side
(Black) Connectors.
11.Turning The Ignition On, Turn The 4
Way Hazards On, Turn The Ignition Off. Allow The 4 Way Hazards To Run For 3-4 Minutes. Turn The Ignition On. Turn The 4 Way Hazards Off. Turn The Ignition Off.
12. Reinstall The Seat. Check Operation Of All Lighting Before Riding In Run, Brake, Turn And Brake/Turn Modes.
